Derale-performance 1 Pass 15" Heat Sink Transmission Cooler Kit Manuel d'utilisateur télécharger pdf

13253-13254-13255-13256-HeatSinkInstructions

APPLICATIONS:

COOLER LOCATION

MOUNTING

HOSE BARB INSTALLATION

SYSTEM CHECK

Transmission Oil

Engine Oil

Power Steering Fluid

Fuel

The hose provided in this kit can only be used for Transmissions and Power Steering Applications. Engine Oil

and Fuel applications require the purchase of the proper OEM Spec hose.

This cooler can be mounted anywhere space permits. When selecting the best location for your vehicle, always consider a

location that will deliver the maximum airflow to the cooler.

1. Holding the cooler in place use a marker to identify the four mounting hole locations.

2. Using a drill and 9/32” drill bit, drill the four mounting holes in the desired location.

3. Using the Bolts, Washers & Lock Nuts provided, install cooler.

1. Using Teflon Tape or a suitable sealant, screw the Hose Barb Fittings into the cooler until snug.

2. Using a wrench tighten the two Hose Barb Fittings.

1. Derale Heat Sink Coolers add a minimum of 1 quart of fluid to your system. Always add a quart of fluid after installation

before starting the vehicle.

2. Always check fluid levels on a flat surface.

3. After installation and vehicle has completely warmed up, check all connections for leaks.

IMPORTANT:

KIT CONTENTS

Derale Performance, Los Angeles, CA 800.421.6288 www.derale.com

Warning: Installation of accessories should only be undertaken by those with mechanical knowledge and are familiar with working on

vehicles. Always use eye protection (goggles, safety glasses or shield). Park the vehicle in a well lit area, on level ground and apply the

parking brake. Only work on a cold vehicle that has been sitting overnight, failure to do so will result in severe burns and injury. Before starting

the vehicle, make sure no tools or any other items are left under hood that could interfere with or be drawn into moving parts of the engine.

Failure to follow instructions can lead to severe damage and personal injury.

INSTALLATION INSTRUCTIONS

SINGLE PASS HEAT SINK COOLER

PART # 13253, 13254, 13255, 13256

QTY. DESCRIPTION

1 Heat Sink Cooler – 3/8” NPT

2 3/8” NPT x 3/8” Hose Barb Fitting

4ft 11/32” OEM Spec Transmission Hose

4 Hose Clamps

QTY. DESCRIPTION

4 1/4-20 x 1” Hex Bolts

4 1/4-20 Lock Nuts

4 1/4” Flat Washers

Please read these instructions completely

before beginning installation

TYPICAL TRANSMISSION INSTALLATION

Trans.

HOT

COOL

Résumé du contenu

Page 1 - SINGLE PASS HEAT SINK COOLER

13253-13254-13255-13256-HeatSinkInstructionsAPPLICATIONS:COOLER LOCATIONMOUNTINGHOSE BARB INSTALLATIONSYSTEM CHECKTransmission OilEngine OilPower Stee

Commentaires sur ces manuels

Pas de commentaire

Derale-performance 1 Pass 15" Heat Sink Transmission Cooler Kit Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Chaudière à eau Derale-performance 1 Pass 15" Heat Sink Transmission Cooler Kit. Derale Performance 1 Pass 15" Heat Sink Transmission Cooler Kit User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Chaudière à eau Derale-performance 1 Pass 15" Heat Sink Transmission Cooler Kit